boost controller help

[Elminsster]

I installed my ebc following this diagram
http://z32.wikispaces.com/file/view/TT_ ... roller.png
For some reason my car won't raise past 9psi no matter what. Any ideas?

[itsa300zx]

Did you remember to disable the stock boost solenoids?

[Elminsster]

Yes, they're 100% removed

[ThisIsSparTTa]

Did you check those bleed-off ports that Spencer@Z1 recommended over on the other forum? I know I missed at least the one on my passenger side. To get to it, you'll need to take off the intake 2 pipes that run to the turbo.

Also, have you done a boost leak test yet?

[Elminsster]

No I haven't checked them. Could that stop it from increasing boost?

[ThisIsSparTTa]

That would be a decent sized boost leak (when I saw mine)...so yes. That was advice from Z1, one of the more respected shops around. You should look into it.

[Elminsster]

Alright. Thanks a lot

[Elminsster]

So I made sure all the bleed off ports were capped. It still is only hitting 9psi

[nissanfreak12]

What EBC are you using and are you relying on the stock gauge? Do you also have a tune to account for the higher boost?

[Elminsster]

Greddy profec b spec 2. No, aftermarket gauge, and yes I have a tune

[nissanfreak12]

That particular EBC can be a pain to set correctly. Had a friend that had one and no matter what he did with the instructions, still couldn't get it to boost right. Granted, I think he had a few screws loose in his head, but maybe you can post what settings you have and another member may be able to see what might be wrong.