Bee *R type III ( dual ) exhuast install pics

[chrispy]

Here they are.

[chrispy]

It fits very nicely , I don't know why I even installed it because when I put the "other" motor in i have to put in the manual driveshaft , and probably take out the exhaust to get some room to work on it.

[chrispy]

The pictures might make it look like it sticks out far , but remember the rear bumper isn't on yet.

[Get240DiZzY]

Nice!

[Anand]

looks good!

[red240ne]

It looks good, and I like how it's not as far spread apart as the Apexi dual.

[chrispy]

I will try to put a sound clip up tommarow if I can.

[Anand]

It looks good, and I like how it's not as far spread apart as the Apexi dual.

N1's aren't spread apart more than this!?!?!?

see:

[TougeMonkey]

Looks soopa nice. Would like to see it with the bumper...but ya can't have everything.

[IvanS13]

Mmmm.... puuuurty.

[skydragoness]

O_O is it all stainless steel? sweet! Bee*R=good choice

i always wanted to get it, but it's pricey

[s0ldats]

sweeeet exhaust...how much did it cosT? and how does it compare to the n1 duals?

[chrispy]

cheaper then the n1 duals amd i got it from acceleratedconcepts.com . Performance wise I do not know since my 240 doesn't run all that well.

[slw240sx]

crispy, got any pics of the rest of the paint work.. is it finished???

my Ca is in the new 240!! i just have to finish up one wirring connector on the ECU ! i sure wish i had some nice 7spoke alloys to put on it when i get the springs on this weekend... j/kanyhow im hoping to have it drive able this week! , whens the motor coming in? i want to see some more pics man!! ill try and get some of my ride on here this week !! Jon

[chrispy]

I have abunch of pics at my cardomain site , but cardomain seems to be down right now. Good luck with the CA , did you do all the re-wiring yourself?