Hi, I cannot understand which bearings do I need. I will get the crank ground and need to get .25mm mains, but which of these?http://cgi.ebay.com/ebaymotors...91405h ... 30541About MS1565 I was told "The 1565's have an overlength flange, do you want that or check out MS2073. That one is a standard length flange."
Help!
Bearings help needed...
-
s13sr20chris
- Posts: 4148
- Joined: Tue Jun 10, 2003 9:32 am
- Car: '89 Nissan S13 w/redtop running 13psi and not leaking fuel anymore
- Contact:
Re: Bearings help needed... (Vetal)
i am not sure if either of those would work. i would advise getting stock bearings from a dealership as they are very forgiving. the hi-po clevite bearings are made for high loads and as such are not forgiving of imperfection on assembly or lubrication. remember the bearing does not do the work, the oil does the work.
-
s13sr20chris
- Posts: 4148
- Joined: Tue Jun 10, 2003 9:32 am
- Car: '89 Nissan S13 w/redtop running 13psi and not leaking fuel anymore
- Contact:
Re: (Vetal)
well, if you want to use them be sure to cross referece the part numbers with clevite so you know you are getting the right parts. they should work if they are the right part.
Clevites are pretty good. I've got the T77's in my build. However, why can't the shop get them? I find that pretty suspicious. If you're getting your crank ground by a reputable shop, they should be able to size your bearings. If they can't I'd look into their history as a crank shop cuz that doesn't sound right to me.