Does anyone happen to have a pic of the backseat removed? I'm going to be running some wires and need to get an image of what I'm doing. Mostly want to see the size of and how many holes to run lines into the trunk.
Thanks.
Backseat Pic
in 5 easy steps.
1) Place your hand on rear seat.
2) Slide it forward and down towards the floor board. Where the bottom edge of the seat meets the back side of the floor board ( at the slit ), there is a plastic latch.
3) Pull it forward. There's two, one in front of each rear seat. Pull both, releasing the seat from the frame.
4) Lift your seat up, and out.
5) Take a picture, and post it for everyone else to see how easy it was.
2) Slide it forward and down towards the floor board. Where the bottom edge of the seat meets the back side of the floor board ( at the slit ), there is a plastic latch.
3) Pull it forward. There's two, one in front of each rear seat. Pull both, releasing the seat from the frame.
4) Lift your seat up, and out.
5) Take a picture, and post it for everyone else to see how easy it was.
Re: Backseat Pic
LOL, fair enough, but what I really wanted was the part your back rests against. Provide the easy instructions for that and I'll be back to post detailed photos of both.
Thanks.
Thanks.
Re: Backseat Pic
Once the lower seat if off...
1) There's like 3 boltss at the bottom of the back seat.
2) Remove those.
3)The seat has "L" brackets that slide down and lock the seat in. so to remove the back seat don't pull forward, but Slide it up instead.
1) There's like 3 boltss at the bottom of the back seat.
2) Remove those.
3)The seat has "L" brackets that slide down and lock the seat in. so to remove the back seat don't pull forward, but Slide it up instead.