awd rb powered 240sx

[MRDOBNS]

hi guys,

i'm new here but not new to the car/tuning community and i have some questions that i hope you can answer. first off i have a 96 240sx that i will be pulling the engine out of this fall and replacing with an rb26. i'm buying a gtr front clip, my question is, how hard would it be to adapt the awd system from that gtr front clip to my 240 chassis? i know that full race has done it and was supposed to release a kit to do this with but its not available. i know that i would have to get some parts fabbed up to make the subframe and cv axels/front drive shafts to fit and i also know that i'll need to get the g sensor for the awd to work properly. any pointers would be greatly appreciated.

thanks ahead of time guys

here is the link to a thread about the full race car

http://www.tamparacing.com/forums/nissa ... 6-awd.html

[#1_Gun]

so i know its been covered before somewhere but the first thing that popped in my head would be the size difference in cars....... I.E. what if you could just cut off your front end and weld on the gtr clip ? I know its WAY more involved than that, but as a place to start, you know? Like hook up your driveshaft to the gtr trans and keep the front the way it came? Im not trying to dumb down this task but if you had the time, money, and resources, i wouldnt think it would be too far-fetched?