autometer tach question

Post by **ibzbro** » Tue Nov 11, 2003 8:14 pm

ok so i have an autometer tach but it is set up for the 4-banger eninge so how can i sent it up for the 6?

Post by **JonPowell** » Tue Nov 11, 2003 8:14 pm

Isnt there a switch on the back?

Post by **ibzbro** » Tue Nov 11, 2003 8:14 pm

nope i looked.

Post by **JonPowell** » Tue Nov 11, 2003 8:14 pm

You gotta get one specifically for a 6 cylinder or with a switch for 4,6, or 8. Time for ebay.

Post by **PROJECTRB240SX** » Tue Nov 11, 2003 8:14 pm

NO ITS NOT A SWITCH SETUP. AUTO METTERS USE A WIRE RESISTOR SETUP. DO YOU HAVE THE INSTRUCTION MANUAL? BECAUSE IN THE BACK OF THE TACH THERE SHOULD BE WIRE LOOPS LIKE GREEN, PURPLE, AND WHITE WHICH ARE MOST COMMON AND YOU NEED TO SNIP ONE OR TWO OF THESE FOR THE CORRECT RESISTENCE TO READ ACURATELY.

Post by **leroy0053** » Tue Nov 11, 2003 8:14 pm

connect the two brown wires in the back for six cylinder just connect them to each other.

autometer tach question

autometer tach question

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums