Anybody seen this? HKS EIDS

[Slo_240sx]

http://cgi.ebay.com/ebaymotors...33557

Just wondering if anybody has seen or used this. Looks like a quick fix to all of us Venting to Atmos.

-Alex

[Yellow4g63]

can that sig pic get any bigger?

[Slo_240sx]

I JUST put it on didn't know it was that big and I JUST made it smaller. thanks for noticing though I wanted to make sure you saw that it was a skyline motor.

[hashiriya13]

I have not used it but when I put the Blitz BOV on my skyline the tune shop over here in Japan highly recommended it if I have stall problems. So according to them if you vent to the atmos and it stalls it is the fix. I was lucky and did not need it. Like I said I used the blitz and was told it should be ok but if I went with one like Greddy i would most likely need it. On my 25 I have the Greddy and even with it recurculated it has stalled but not to often. Hope that helps.

[Slo_240sx]

Really... Good bit of information. I'm running a blitz and had a BIG stall problem always at the end if decel but found out my timing was a bit off. Redjusted and never stalls... but i haven't driven the car for more than a 1/4 mile at a time since it isn't painted yet and I don't have a valid license. It hauls bit i'd love to take it out of a long drive home. Thanks Hashiriya

[themadscientist]

it will fix the stalling problem if proper blowoff setting does not. It oversamples the AFM signal so for that second when when you get off the gas and vent the BOV and the reading goes goofy it smoothes out the signal. I never had a car where I couldn't work the pedal and prevnt the car fom stalling so that is some of my money HKS didn't get.

[Slo_240sx]

yeah but its always a pain to blip the gas again after a letoff. HKS made it for a reason, I'd rather do that than just make it so much more inconvient.