AMS/Turbo240 Pro Series Rods Now in stock!

[Chris@AMS]

We are now excited to offer the KA community yet another new rod. We have collaborated with another company to offer a high grade billet connecting rod. These are called the AMS Pro Series connecting rod.

These new rods have specific advantages to the other rods that are currently on the market. For one, these rods are about 50 grams lighter than the Crowers that we normally run (~650 grams). There are no strength compromises and the rods are made to hold in excess of 900 hp! Those of you that are running or planning on running big HP need to pick up a set of these rods! For under 500-550whp we recommend our sportsman rods.

These will not require you to clearance your block and are a direct bolt in. The weights of the rods are measured individually and written on each box for extreme accuracy during assembly. These rods do include ARP 2000 fasteners which have been proven to work well over and over again.

We are confident that these rods will fill any needs you may have for horsepower or torque potential. If you have any further questions please give us a call or send us and email.

http://www.amsperformance.com/...d=154

If you have any questions, post em up!

ThanksChris

and oh yeah... whats this?!

[Poor_S13_Driver]

Oh yea.... about time

[frsh13]

cant wait to see that manifold finished!...

[Poor_S13_Driver]

Any kind of projected time frame when the manifold would be avaliable? Also do you think theres a chance that a SOHC manifold would be made?Assuming the intrest/support is there?

[rlvq35de]

You did it now chris

[Florida240sx]

Where be the wastegate flange??

[GlacierFreeze]

Would assume it's on the inside pointing towards the block.

[epokh]

Mmmm..sweet!.......I buy a mani, you guys design a better one...I buy crowers, you guys make lighter ones....I decide on a t3/t4, you guys come out with the AMSgt32 & 35......stop it you bastards!!

And yes, you've done it now, prepare for 5,968 pages of "when's the mani gonna be ready?"

I assume my turbo has shipped Chris?

-James

On a side note: when's the mani gonna be ready?

[Chris@AMS]

Any kind of projected time frame when the manifold would be avaliable? Also do you think theres a chance that a SOHC manifold would be made?Assuming the intrest/support is there?

If there is interest and a car to build it on, I don't see why not, I deff wouldnt get your hopes up for the very near future.

This manifold should be available shortly, we just need to make it fit in an engine bay.

[Chris@AMS]

The

Where be the wastegate flange??

It should be pointing in towards the block when it is done.

[Chris@AMS]

Mmmm..sweet!.......I buy a mani, you guys design a better one...I buy crowers, you guys make lighter ones....I decide on a t3/t4, you guys come out with the AMSgt32 & 35......stop it you bastards!!

And yes, you've done it now, prepare for 5,968 pages of "when's the mani gonna be ready?"

I assume my turbo has shipped Chris?

-James

On a side note: when's the mani gonna be ready?

Your turbo should be well on its way by now!