Aluminum Debris Shield - Who all would be interested?

[swimshark]

Ive heard from a few J30 owners and myself have all hated how the debris shield under the motor over time sags and hangs down below the car. I made an aluminum one for my car and posted pictures below. Was seeing who all would be interested in buying one if I were to make a set of them to sell? I do not have a price quite yet but don't expect it to be too expensive.

[fourdrinie]

in for one!

[swimshark]

lots of views but not much interest....

[yodawill2000]

Might throw a ballpark price out there Shark man.
Alot of peeps take the OEM off and don't understand how it helps during Summer heat !!
As the fan pulls air through the Rad the shield acts as a plenum to keep the air flowing to the rear.
Without it in stop and go traffic the air recirculates in the front pulling HOT air through the rad instead of Ambient.
It does more than just block debris.

[swimshark]

$125 + shipping
The one I have in mind of making will replace the whole shield. Mine is currently 2 piece using part of the OEM shield up front. This one will bolt all the way from the front bumper to the subframe behind the oil pan. Will include nuts, bolts and a pair of quick release cotter pins. I added 2 bolts to the subframe section that runs in front of the motor. You can see where they are located in the 3rd pic in original post. Will include some written instructions on installing. This does away with the section that bolts up in to the subframe where most of the OEM shields rip a part from.

[yodawill2000]

Still have access to the OEM oil filter location with that shield ?

[swimshark]

Yah you do cause its made similar to the oem shield. Just has a few different mounting points.