Air Vent...

ONLY for ADVANCED technical discussion about the 240sx!
User avatar
1drifterX
Posts: 43
Joined: Mon Jan 20, 2003 4:54 pm

Post

Hey all,I have a 1990 240SX SE. and a while back when i got the car, which is older but in good condition, there was leaves and just a bunch of stuff that would blow around behind the air vents. i removed the drivers side vent(the skinny taller one) and have not been able to put it back in. there are 3 movable vents that stand up and are connected to eachother and the middle one has the knob that is supposed to make all of them move at the same time. And ofcourse there is also the vent cover which clicks into 4 corrisponding slots. If any expert has any advice on this simple problem your advice would be much appreciated!

THANKS,

1drifterX


NISTECH
Posts: 10585
Joined: Sun May 25, 2003 4:17 am

Post

it is suppose to just push back in..unless it got damaged removing it

User avatar
1drifterX
Posts: 43
Joined: Mon Jan 20, 2003 4:54 pm

Post

its not that simple, i wish it was. not too difficult either. there are 3 blades as i mentioned in the above post. that have to allign a certain way. anyone???


Return to “240SX Technical Forum”