Aftermarket Seats

[saintnick83]

I just purchased aftermarket seats for my 93 HB. Has anyone done an install on these. There are humps in the floor where the factory seats bolt in. I can cut out the passenger side bracket and just bolt the seat down, but on the driver side there is a raised area where the exhaust goes. I have an aftermarket exhaust and the indentation is empty. Should I just bet it with a hammer? Are there factory brackets to fit an aftermarket seat? (I would prefer this) Any suggestions?

[onosqv]

if it's the bottom mount reclinables, you can get Sparco (i.e. Wedge Engineering) Brackets from your favorite place, whether on ebay or some local shop. If it's a corbeau, you need corbeau ones.

If it's a sidemount, you need side mount ones, etc.

You can custom fab, but you will need to weld/deweld - stock rails do not bolt up to aftermarket seats - that's something the sellers sometimes forget to tell you since they want to take your money.