Post by
98240 »
https://forums.nicoclub.com/98240-u35691.html
Fri Dec 01, 2006 6:32 pm
I am getting my ems tuned tommorow. I want to install a aem map sensor when I get there to reduce the amount of money that I am going to have to pay. Unfortunately I am horrible with the ems and I dont understand it one bit. Well I have been reading on aempower.com and I cant seem to find where to wire the map sensor. I am not sure if you wire into the existing maf wires or if it goes somewhere else. On the aem forum it seemed people were wiring it directly to their ecu. I am going to keep researcing but I thought I would post this up in case someone has already done this and can give me a quick answer. This is what I know about the sensor:Pin A Ground inputpin B +5.0 volt inputpin C signal outputI have a 98 nissan.