95 200sx se govenor

[kd200sx]

hi. guys and girls im new to this site so please help me out. i have a nissan 200sx 1995 se not se-r and i am trying to make it a project car. i wanted to find out how can you take off the govenor on my car because it sucks to have to race and have a car pass you when your going 110 mph. i tried UNPLUGGING the TRANSMITION speed sensor (VSS) but i hate to look at my car with the speed im goin not being able to be seen because it doesnt go up or down. can your please help me out here asap is their another way or any chip i can buy around $100 to take off my gov. thanx

[nametakennow]

The kind of race where a stock 200SX SE hits the governor probably isn't legal to begin with. Specifically, the GA16DE - even with any mods I've heard of one having short of the rare turbo - would have quite a challenge getting to that speed.

Drive smart, then figure out the whole "project car" thing.

To answer the question: search, there's something you have to cut. I think it's the same as the 240 boys do.

[RED_DET]

Several different methods have been tried to eliminate the governor, most have failed and that is on the SE-R. Driving a SE @ 110mph is almost pointless anyways, because it would take forever to get there.

[1.6beaviss200sx]

jim wolf tech makes programmed ecu for your application try looking there

[EZcheese15]

jim wolf tech makes programmed ecu for your application try looking there

That is the only way to do it "right".

[Chris859]

Looking at some wiring diagrams I have laying around from when I built one of my friends a swap harness... I am pretty sure that if you were to cut the wire connecting to pin #26 on the ecu it would disable the speed limiter as well. Considering that is the wire the ecu uses to read the speed signal, cutting it would keep the ecu from reading the vehicles speed. But as stated above, there really is no point in doing this on a ga16... And it is also one of those things where I feel if you need to ask how to do it - you don't need to be doing it!