555cc injectors from deatschwerks and t3 super 60

[98240]

I have not yet purchased the injectors but I am going to if they are going to work for this setup. I am pushing for the 300rwhp mark. I am wondering what the highest hp rating is for these injectors and also if this turbo is going to be sufficient to make this for me. I have a stock block. I am going to be using the aem ems to tune this. Also if anybody has the same injectors and turbo with a ems that would like to share their tune with me that would be awesome. Open to all suggestions.

[lrb_2000]

Whoa. If you have the money for EMS then you should probably get a bigger turbo. I THINK that the super 60 will get you 300whp, BUT it's going to take maxing it out to get you there probably... Somewhere around 20-22psi? I'm not sure. Here's a chart for injectors. 555cc injectors will be more than enough.

[98240]

I bought the ems used so i got a good deal on it. I would get a bigger turbo but i am now broke so I have to wait a while. Thanks for the info

[lrb_2000]

Oh haha.. Yeah then. Is this going to be on a stock engine? If so, I dont' think you could hit 300whp without something going wrong.. 20lbs is a lot to run on a stock engine haha.. but I guess you don't really know.

[98240]

What would be the safest limit on a stock block? I am at 229rwhp right now but I may be a little higher since I fixed some major boost leaks. Running 10psi

[lrb_2000]

I don't know.. I'm running my super 60 at 10psi on my KA as well.. I may up it to 12-14psi.. but I'm not sure what's safe either.

[KATwo40]

It's all in the tuning. You can run 20psi from a T04E on a stock block KA (has been proven many times) for a net of around 380-400whp, but you MUST have a good tune.

[Jookmasta]

i run 17psi on my stock block and have been doing so for close to 2 years with no issues..............and yes this is with a str8 t3 60 trim...............

[98240]

What are your numbers right now? What are you using to tune?