Post by
S-tec Motorsports »
https://forums.nicoclub.com/s-tec-motorsports-u94813.html
Thu Nov 08, 2012 8:37 pm
When I ordered my drive shafts from driveshaft unlimited in Ill. He found something from a truck that was the same. Just measured the number of splines and width. It is something really common in the states, but he could not tell me what it was, so I highly doubt it was a 300zx one.
It worked fine, I did have to sand about 1000th off of it so it would not bind, but it can handle up to 1000hp now. It was a one piece metal tube I had him make. Was cheap too.