5 Speed Swap Question

ONLY for ADVANCED technical discussion about the 240sx!
Post Reply
redhb240SXS13
Posts: 409
Joined: Fri Nov 17, 2006 12:10 pm
Car: 1992 240sx Coupe and 1995 240sx

Post

I'm just gonna start with I know there are tons of write-ups but my question isn't answered in any of them. My question is this; What the hell do you guys use to drill the upper hole for the master cylinder stud to go through. My cordless craftsman drill is too big too fit under there. Just looking for suggestions . Thanks guys

Top
2point4turbo
Posts: 4
Joined: Sun Apr 19, 2009 3:28 pm
Car: 1990 240sx, 5 speed swapped, DOHC swapped,

Post

i had no problem doing it with my cordless drill... maybe try renting/buying/borrowing a right angle drill. should be simple with that.
Top
redhb240SXS13
Posts: 409
Joined: Fri Nov 17, 2006 12:10 pm
Car: 1992 240sx Coupe and 1995 240sx

Post

Hmm... the battery on the bottom of mine is hitting the firewall/ floor where the two meet. I'll look into a right angle drill. Thanks for the tip.
Top
Post Reply

Return to “240SX Technical Forum”

Search for Nissan stuff on ebay!
Find Your Forum!

 

NICOclub's Nissan forums and Infiniti forums and all affiliated sites are the property of HDS Holdings, Inc.
They are independent publications and are not affiliated with or endorsed by Nissan or Infiniti.

Information Copyright © 2000-2026 by NICOclub, all rights reserved. Material may not be copied or reprinted without written permission.

Privacy Policy