i have a built 350 that is pushing about 350, 400 hp and i have a 1990 240sx and i was wondering if anyone has done this swap yet, its not an LS1 its an older motor but ive already got it built and any assistance or feedback would help!! thanks !!
Modified by strongmancasey2009 at 9:59 AM 10/2/2009
350sbc swap
-
strongmancasey2009
- Posts: 7
- Joined: Fri Oct 02, 2009 5:05 am
- Car: Currently 1999 Jetta
- Contact:
-
thrasherx89
- Posts: 183
- Joined: Thu Jan 10, 2008 8:34 pm
- Car: 90 hatch (91 dohc, tein, z32, ss, injen, energy, b &m)
Re: 350sbc swap (strongmancasey2009)
ive seen it on the internet before, looks like a pretty tight swap haha
-
thesledshed
- Posts: 2
- Joined: Sun Oct 04, 2009 2:30 pm
- Car: 1989 240sx and 1991 240 with v8
-
strongmancasey2009
- Posts: 7
- Joined: Fri Oct 02, 2009 5:05 am
- Car: Currently 1999 Jetta
- Contact:
Re: (thesledshed)
WHAT SIZE MOTOR DO YOU GOT IN IT?? AND WHAT KINDA transmission DID YOU USE?? IM HOPING THE HORSE FROM THE MOTOR DOESNT TWIST THE BODY
-
thesledshed
- Posts: 2
- Joined: Sun Oct 04, 2009 2:30 pm
- Car: 1989 240sx and 1991 240 with v8
Re: (strongmancasey2009)
350and 350 trans. had drive shaft made.The body has not twisted yet and rear has held up..So far.
-
strongmancasey2009
- Posts: 7
- Joined: Fri Oct 02, 2009 5:05 am
- Car: Currently 1999 Jetta
- Contact:
Re: (thesledshed)
so ur runnin an automatic??
Re: (strongmancasey2009)
There are 1000HP+ ka-t's and that doesn't twist the body. I doubt a 350-400hp SBC will.strongmancasey2009 wrote:WHAT SIZE MOTOR DO YOU GOT IN IT?? AND WHAT KINDA transmission DID YOU USE?? IM HOPING THE HORSE FROM THE MOTOR DOESNT TWIST THE BODY