350 HP? tell me what you think.

[docktercolin]

Been working a ton of overtime and getting ready to lay down some coin. Big question is, Will this be enough to get me in the 350-375HP range. GT2871 .86BC 264's springs and retainers MSD 72lb injectorsEnthalpy tuneCometic 86.5 1.1 HGZ32 mafs

Here is what i am working with.Red topWB 255, nismo regBlitz FMIC, Blitz BOVMeagan exhaust manifold, collectorTanabe full 3in exhaust with 3in. catco cat.

Thats the ins and outs of the pump. Stock bottom end, but everything else supported. Like,Blitz SBC 2, Apexi NEO, Full assortment of cobalt gaugesKoyo rad, Nismo thermostat, samco hosesGreddy oil pan, oil cooler, SS turbo lines, ETCBlitz single disc clutch (for now)Lots more that probably doesn't really matter in these regards.

Any suggestions or comments would be great. I want this to be a all around fun little monster to drive on the street, strip or pullin on the unaware stang or vette.

[240life]

you should have no issues with that hp goal

[S14toRPS13]

Sounds like you got the parts you need. I'd rather go with a stand alone or Nistune to fine tune your set up a little bit more though.

[V8slayr]

Dont worry too much on the tune. As long as it is tuned for your setup the enthalpy ECU will get you your goal and run great. I love mine.

[S14toRPS13]

Dont worry too much on the tune. As long as it is tuned for your setup the enthalpy ECU will get you your goal and run great. I love mine.

I'm a firm believer of a good tune. Not only will you gain power all across the board. A good tune is key to reliability and a healthy motor.

[MastaYu]

^ good tune

[supreamS14]

Cometic 86.5 1.1 HG

Cosworth

[OM3GA]

Cosworth

OR Tomei

[dc1984]

yea, everything looks like it'll be alright but i agree on the tune. im about to go with nistune myself after i get back home. seems like the best standalone bang for ur buck

hope everything goes smooth

[david200095367]

OR Tomei

OR Apexi

[docktercolin]

How much does the nistune run? and how do i find out if there is anyone close to nashville that i can trust to do the tune. I have no problem paying for the dyno time, just want a safe tune and reasonable numbers. The way i figure it, I have about 8k into the motor and everything supporting it. Another three in the new upgrades. Dyno time is almost cheap.Also. Whats wrong with the cometic? I know you usually get what you pay for but i haven't really heard anything bad. so far

[supreamS14]

OR Apexi

Or POWER ENTERPRISE

Whats wrong with the cometic? I know you usually get what you pay for but i haven't really heard anything bad. so far

Search cometic in the sr fourm.

DONE!

[docktercolin]

Done. And done. Maybe? Said i have been working a ton. That is why i need the help from all of the informed nissan guys. Believe me, i have been tryin. Did find from my searches, i don't want to send any of my hard earned cash to Jason garret Young. This forum has been a great asset to me in the past and i hope that some day i can be a asset for someone else.

Apexi or Tomei head gasket? MMM, I'd have to go with Tomei. Dammit, now i want Tomei cams and springs. Thanks guys, more overtime!

[docktercolin]

Just watched a great vid on nistune. That is the way to go. Hondata for nissan! Sweet in between Rom and stand alone. Thanks again for helping me spend LOTS of money.