300ZX wheel fitment question.

[LastletterfirstloveZ]

Hey guys! New here but just about to finish up a twin turbo swap for the Z and i want a set of new wheels just unsure which direction to go. Im looking at getting the varrstoen replicas of the TE-37's since they're pretty inexpensive and they have a few good options for sizes. I would prefer to run an 18 inch wheel set up but if needed a 17 inch set up will do.

Cars suspension is stock and stock height also.

For 18 inches i was looking at running
18x9.5 with a +22 offset for the front
18x10.5 with a +30 offset in the rear.

Im worried about the rears being too wide that ill have to roll the fenders to get proper fitment and I'm not sure I'm looking to do that..

for 17's i was looking at running
17x9.0 +30 offset front
17x9.5 +30 offset rear

i would like for them to sit flush but a little stance would be ok . any suggestions?

Thanks guys!

[LastletterfirstloveZ]

http://www.twinturbo.net/nissan/300zx/f ... these.html
Such as a little camber like this. ignore the stupid stickers and the hi-power..just like the way the wheels fit. any idea of the offset to achieve that? seems like they're 18's to me.

[Ziggy1621]

Welcome to Nico! I moved your thread to 300zx (Z32) general.

Here is a good read: wheel-fitment-and-tire-size-guide-t512311.html