300zx 92 lower intake manifold

[nathanmoris]

Hi i have a 92 300zx n/a and i need to replace the knock sensor. i removed all the nuts and bolts on top that i see and removed the timing belt and the idler pully that sits at the end of it. The front end of end is lose enough where i cen move it up and down but the back towards the egr wont come up. The book says nothing to help so i was wondering maybe someone out in the Z world could help me thanks for any help jonathan

[nsrZ32]

There's two bolts by the EGR actuator on the back. Make sure you remove those and unbolt the EGR. Then it will come out.

[nathanmoris]

oooo ok ill try that thanks

[nathanmoris]

i took the two bolts out and i still cant get the intake manifold off. its a whole lot losser but i have the other tubes above the egr ( i guess some coolent line) that are in the way and i can get those outta the way to get it out. any help would be nice thanks