2012 Versa SL HATCH TAKEDA SRI INSTALL PROBLEM

[sernismo25]

Hi, I need help and advise I have a Takeda short ram that I bought from versaspeed and I tried installing it on my 2012 SL hatch and everything seems to be ok until I shifted the car. The intake pipe hits my brake reservoir. I tried turning the pipe and experimented but it still hits. Then i noticed that on my versa the brake cap is bigger from my friend's 2008 versa S. I have ABS that's what he said that is why my reservoir cap is bigger. I tried pulling the pipe a little bit out from the throttle body and it does clear a little better but when I tighten the clamps the pipe will fall off because there is not much to hold on to. Please help if there is anybody had this same problem and a solution. Right now I still have my AEM CAI on the car, but I would like to use the SRI.

[versaspeed.com]

Let's meet up and figure it out.

[Jape]

With all due respect, why not stick with the AEM..

[sernismo25]

That's what I have right now. Just little scared of hydrolocking my engine, because it happened on my 93' Integra, my nephew borrowed it and messed up the engine. Had to go get a new engine, but then again it got stolen and never found it. hahaha. Thanks though. I am actually selling the Takeda SRI since i made up my mind to keep the AEM.

[Jape]

Where are you selling it? On this site or somewhere else. I would be curious to know what you would like for it

[sernismo25]

Where are you selling it? On this site or somewhere else. I would be curious to know what you would like for it

Jape, where u located? I am actually selling it $120.00 let me know where you at maybe i can ship it to you free. I am in California txt me at 62638389496 since it is hard for me to go online all the time. thanks.

[sernismo25]

Jape, got my number wrong, it is 626-383-9496, I still have it if you interested.

[Ben_B]

That's what I have right now. Just little scared of hydrolocking my engine, because it happened on my 93' Integra, my nephew borrowed it and messed up the engine. Had to go get a new engine, but then again it got stolen and never found it. hahaha. Thanks though. I am actually selling the Takeda SRI since i made up my mind to keep the AEM.

Suggestion:

AEM intake has two pieces of pipe. You can just remove the lower piece that goes down to the wheel-well and attach the airfilter to the top piece. I believe it can neatly rest on a little perch that's there (forget exactly where that is, just that it's there.) Should work fine as an SRI.

[Jape]

Just recieved the intake today. Sounds awesome and instal was simple, couldn't be happier. Thanks again Mike!