2011 Infiniti m56x LED install

[ezcustomz]

So I have the LED Glow 4 tube kit with control module, basically the setup requires the tubes to be ran through the dash to the both front footwells and 2 under the seat,My question is what is the easiest way to run the tubes from the front driver side to the passenger side. Will need to run atleast 2 tubes discreetly for the passenger side.

[Debonair]

I used a length of threaded rod to push wires from the passenger footwell to the drivers footwell for my DRL project. I just taped the wires to the end of the rod and then carefully pushed it through. It quickly found its way through. Any thin, slightly flexible rod or stick will work. Or maybe the whole tube it's long enough to grab on the other side.

Just take your time and don't force it of course.

Also... PICS OR LINKS to what you are installing!

[ezcustomz]

See the thing is I tried to find a opening somewhere deep down and it's very little to no space, and the tube is kinda big for it to fit thru if it's that small of a spacing unless I'm looking at the wrong space .. Here's a pic of what I purchased $35 from led glow

[Debonair]

So I would push the wire through then. I'll try to grab a picture or where my wire goes through later. Where are you putting the controller box?

[ezcustomz]

I would be mounting it either on the side of the footing area or into the center console compartment if I can

[M37owner]

Can you cut the wire a few inches from the LED tube and then run the wire to the other side of car, and then splice back together finishing with heat-shrink? Is this wire just the standard 16-18ga 2-conductor stranded wire, or something unique?