2009 Nissan Maxima Front Control Arm Torque Specs

washuler · Post by **washuler** » Tue May 22, 2018 5:47 am

Does anyone know the factory torque spec's for a 2009 Nissan Maxima front control arms? I need the front bolt and rear bolt torque spec's along with the ball joint torque spec's. I understand the car needs to be loaded (on the ground) to torque.

Thanks,

Bazinga

Read more: http://www.city-data.com/forum/nissan-i ... z5GEbDIKGX

Post by **NutriaforBreakfast** » Tue Jul 10, 2018 1:52 pm

Probably pretty tight. 4th gen control arms are 87 ft pd to 108 ft. pd. Best if car is on ground
but good luck with that. I think the ball joint is really the "traverse link" .

Post by **amc49** » Sat Jul 14, 2018 9:47 pm

The rubber bushings if equipped self adjust to be neutral if you tighten on the ground, tightening in the air lets them be locked in a twisted state, thus ensuring they do not last as long. I started doing them that way back in the '70s on race cars before the OEMS ever began to do it.

2009 Nissan Maxima Front Control Arm Torque Specs

2009 Nissan Maxima Front Control Arm Torque Specs

Re: 2009 Nissan Maxima Front Control Arm Torque Specs

Re: 2009 Nissan Maxima Front Control Arm Torque Specs

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums