2002 QX4 under engine bay splash guard fasteners

[brickbox]

The knuckleheads at the oil change shop forgot to tighten the fasteners that go at the back of the under engine bay splash guard.

So the splash guard is now flopping around just held by the bolts on the front. Can someone please tell me what the size of the bolts are? Or are they just press clips?

Thanks!

[QX4ME]

The bolt size at back is the same as that in the front. You can take one in the front and match it in hardware store.

[Micallen]

Here's the actual part: https://www.ebay.com/itm/1-PC-PACK-GENU ... 2749.l2649

[brickbox]

Here's the actual part: https://www.ebay.com/itm/1-PC-PACK-GENU ... 2749.l2649

Perfect - thanks!

[Micallen]

Here's the actual part: https://www.ebay.com/itm/1-PC-PACK-GENU ... 2749.l2649

Perfect - thanks!

Note that it's 1 per pack. I imagined it said 8 or 10 or something. I need 4 or 5, and I ordered 1.

[brickbox]

Hahaha. I noticed that. I ordered 4 to put them on the back.

[brickbox]

I found these as well in case someone is interested. They cost about half as much as the Nissan branded bolts.
https://www.ebay.com/itm/141803229366

On a side note, local dealership quoted me $3.12 per bolt + taxes