Post by
PonyGuy »
https://forums.nicoclub.com/ponyguy-u149249.html
Wed Dec 09, 2009 4:20 pm
Thanks guys for the advice, but unfortunately when I was troubleshooting yesterday I inadvertently cleared the code(s). Doh!!
At this point I can get the engine to turn over and actually idle, but the minute any strain is put on the motor (read - put vehicle in gear) it gives out and stalls. It will sit and idle til it runs out of gas. I can also rev the engine manally at the throttle body and it will maintain whatever RPM I run it up to. I just can't drive it. FRUSTRATING!!
I am really at a loss now. Any further suggestion? Oh and I should also mention that it rained here like crazy for the last two days, but I did not run the truck through any large puddles, but I am seeing water coming from the tailpipe and what I beleive to be the catalytic converter - about 1 cup in total.
Any help or suggestions that anyone could provide would be greatly appreciated!!
Oh and Alexf20c, my truck looks exactly like your (minus the mods of course!)