2 sensors where do they go

Post by **91240sxhatch** » Sun Sep 07, 2003 9:24 am

there are two sensors that are attached to the same plate that the ignitor chip is mounted on the s13 redtop that have what looks like vaccuum lines that would run to them. i was wondering if i needed to hook these up and if so where do they go, or if ayone knows a web site that could show me a diagram of where to wire them. thanks.

Post by **VitaminT** » Sun Sep 07, 2003 9:24 am

The green one is the factory boost controller. The other one is something to do with the carbon canister. I think it is the evap purge valve. I do not have either one hooked up.

Post by **Sleeper_RPS13** » Sun Sep 07, 2003 9:24 am

What if I'm not running a stand alone boost controller? Would I still be able to disconnect that one? Does the wastegate solenoide mechanically regulate it to 7psi automatically?

Website · Post by **gtune4** » Sun Sep 07, 2003 9:24 am

mine manually boosts to 8psi, any boost controller will give you better response.

the stock one gives slow response in 1,2,3 under 29mph and quick response in 4 or 5 or above 29mph.

Post by **Movingviolation240** » Sun Sep 07, 2003 9:24 am

just cut them both off and tape them up, not required.

Paul

Post by **91240sxhatch** » Sun Sep 07, 2003 9:24 am

thanks for the info, should i plug them in and tape them off or can i leave them completely out

2 sensors where do they go

2 sensors where do they go

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums