2.5 Oil catch can mod

1 post • Page 1 of 1

D-Roll: Posts: 1501; Joined: Tue Nov 20, 2007 3:24 am; Car: 08 Nissan 350Z Touring Coupe; Location: Ruskin FL; Contact:
Contact D-Roll

Website Yahoo Messenger

2.5 Oil catch can mod

Quote

Post by D-Roll » Mon Aug 11, 2008 12:38 am

After a lot of research, I did this lil mod today. Total cost was about $22. The below link is a DIY on a QR25 motor, from a Nissan SpecV but it's the same steps for our 2.5's. It's basically preventing oil from going back into the intake manifold from the crankcase (PCV valve) therefore preventing sludge build up.

http://www.401motion.net/forum...=1769

Top

Post Reply

1 post • Page 1 of 1

Return to “Altima General Discussions”

NICOclub's Nissan forums and Infiniti forums and all affiliated sites are the property of HDS Holdings, Inc.
They are independent publications and are not affiliated with or endorsed by Nissan or Infiniti.

2.5 Oil catch can mod

2.5 Oil catch can mod

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums