1996 200SX SE-R Remote start issue

[bambikiller3]

Hi,

I'm new to the forum, I drive a 1996 200sx SE-R 5spd as my winter beater. I live in MN, so remote start is very nice to have in a winter car.

Here's the issue, i can't find a correct wiring diagram for the ignition harness for my car. Usually I use the12volt.com for diagrams, however the wires listed on their diagram don't match the colors under my dash.

I have a white/red stripe as the 12v constant on my harness. none of the diagrams i've found list that as a color in the harness at all. I metered the rest of the wires in the IGN harness and i have it hooked up as a best guess. The remote starter works but the starter gear does not disengage. All my accesories turn on and the car does run via remote, so i'd assume that i have the 2 ign and acc wires correct.

I am using a Ready Remote Starter from DEI, if it matters. I have installed this same model in 3 other cars, this is the first time i am having any trouble installing it.

I hope this gives everyone enough info.

Thanks for the assistance.Rob

[zerepdivad]

I've had quite af ew of those ready remotes crap out on customers of mine who brought them to me. But your issues is likely second starter. Generally nissans have 2 starter wires in the ignition harness. Did you hook both up?

[bambikiller3]

I only hooked up one starter wire. Any thoughts on color of or how to tell what wire it is?

[zerepdivad]

Use a multimeter and it will get 12 volts while cranking only.