http://lamin-x.com/ecommerce/o...648d9
Modified by Slappy at 7:48 PM 5/8/2008Lamin x wrote:TO INSTALL:Small sized applications may be applied dry and medium to large light installations may be applied wet for best results.
First, Clean lens thoroughly. Then peel backing off of film (prevent the film from touching any foreign surfaces). Wet application: spray a very light mist of water onto lens (one or two sweeping sprays from 10-12 inchs away is sufficient). Then align and apply film to one side or center of the light or area. Then using a plastic application card, press down/sweep the remainder of the film across the light. If large bubbles are present or film is misaligned, peel up the film to that area and apply again. If film is not precut then use an X-acto knife, triangular pointed knife, or razor blade to trim off the excess film. If product is precut then remove the handling tabs.
SETTLING:Small air bubbles and creases/ripples will disappear over time as the film settles and is warmed. Minor scratches will also disappear over time and after film maintenance by waxing or applying 303 vinyl conditioner.
