Alarm + Remote Start System??

[Chrispd100]

I just purchased a alarm/remote start system for my versa.... now i have installed one before on my other car but its a 1977 and well the Versa is 2007.. Has anybody done an install with something like this on there versa yet? or Anybody in PHX that wants to help me with this? Anything i should not touch or be aware of? Thanks

[reyes1212]

oh snap in PHX huh?you do anything else to your car?I migt be able to help

[Chrispd100]

Like what?

[Chrispd100]

hey my aim is lefthandman709... talk to me on that....

[Clipsed]

be very careful, that is all I will say, I never recommend anybody do alarm installs themselves, ESPECIALLY remote starts though.

[Chrispd100]

anything specific i need to watch for and be careful around? i have done then before with no problems, but this car is much newer....

[KimberKenobi]

and this car also has an immobilizer for if it is tampered with...

[Clipsed]

today's car electronics systems are very integrated, and are very delicate. If you happen to wire something wrong, you can be in a heap of trouble. Also this car has air-bags, and you are not supposed to disconnect the system, or you could accidently deploy the air bag or create a malfunction, or turn on the air bag code and need it reset. But you need to test for wires, as always. I will help you out and give you the wire codes that I have, BUT like I said as always no matter what even if you do have color codes, ALWAYS DOUBLE CHECK WIRES WITH A DMM, NOT A TEST LIGHT!

I express that firmly, and you assume any responsibility using a test light, and any of the following codes and installation you assume all risks and responsibility and in no way will I be held accountable if anything should fail or go wrong.

Here are the wiring codes I have attained.

12volts Blue Ignition harnessIgnition Red Ignition HarnessHeater/AC Yellow Ignition HarnessStart White Ignition HarnessHorn Pink/Silver dot(-) Ignition HarnessLock Gray(-) Drivers Kick Panel 16 pin white connectorUnlock Brown(-) Drivers kick panel 16 pin white connectorBrake Red/2Silver dots(+) Drivers kick panel Harness to the rearParking Lights Gray/1Sil.Dot(+) Drivers kick panel Harness to the rearLF DoorPin Brown/2sil.dots(-) Drivers kick panel Harness to the rearLR DoorPin Orange/2sil.dots(-) Drivers kick panel Harness to the rearRF Doorpin Lt/Blue/2Sil Dots(-) Passanger kick Panel Lower white connectorRR Doorpin Gray/2sil. dots(-) Passanger kick Panel Lower white connectorTach Green 3 pin connector on drivers side of engine(no need to take off the engine cover)

If you need any help or suggestions, feel free to ask. Also since you are doing a remote start install, I HIGHLY recommend and suggest that you use heat shrink and solder your connections. Remote start installs are treated with extra caution, so please make sure you grab all required connections and please don't use a cheap knock off or off brand RS system, it will only give you problems, trust me. Only wire that I can think of off of my head that was not listed and you will have to test for is the PARK/NEUTRAL wire, you will need to test for that wire(s). I also hope that you have a knowledge of diodes and relays as you more than likely will need to use them in installing the system. All of the preceeding is why I always recommend a professional shop do the install if you have little to no prior knowledge, or in anyway are uncertain in your ability to perform such a task, BUT if you believe you can do it, by all means try, because you will learn through trial and error.

[Clipsed]

and this car also has an immobilizer for if it is tampered with...

AHHH YES, ty Kimber, I forgot about the immobilizer, you will need either a immobilizer bypass unit, OR a chipped key that IS NOT cut to leave in the car for the RS system to work.

[KimberKenobi]

yeah! I contributed ;oP

[Chrispd100]

Anybody know where i can get a more detailed color codes?

[Clipsed]

lol what do you mean more detailed? That is as detailed as it is going to get, what do you want pictures too?

[CodeRed]

If anything I would get it installed by a nissan tech because they know what everything is, iyt wont be cheep but it will be worth it.

[Chrispd100]

Actually yea, pictures would be great.... If I could get some, awesome...

[Kolk1]

I know it was posted above, but Ill post the same thing but from my source.

12volts blue (40A) + ignition harnessStarter white + ignition harnessSecond Starter N/A Ignition red + ignition harnessSecond Ignition N/A Third Ignition N/A Accessory yellow + ignition harnessSecond Accessory brown + ignition harnessKeysense green or lt. green + ign harn or BCM, pin 37, wht 40P plgNotes: The BCM (Body Control Module) is behind the glove box.Power Lock gray - dr kick or BCM, pin 45, wht 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Power Unlock purple to blue - dr kick or BCM, pin 46, wht 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Lock Motor gray to lt. blue 5wi dr kick or BCM, pin 65, blk 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Unlock Motor green 5wi dr kick or BCM, pin 59, blk 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Parking Lights+ gray + driver kick, harness to rearNotes: Can also use pink to purple (+) in the passenger kick, harness to the rear.Parking Lights- N/A Hazards blue - switch or BCM, pin 29, wht 40P plugNotes: The BCM (Body Control Module) is behind the glove box.Turn Signal(L) purple + dr kick or BCM, pin 60, blk 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Turn Signal(R) white + pa kick or BCM, pin 61, blk 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Reverse Light yellow or pink + either kick, harness to rearDoor Trigger see notes - each kick or BCM behind glove boxNotes: The LF door is lt. green to brown in pin 47, white 15 pin plug. The RF door is lt. blue in pin 12, white 40 pin plug. The LR door is white to orange in pin 48, white 15 pin plug. The RR door is yellow to gray in pin 13, white 40 pin plug. Use all four wires and diode isolate each.

The BCM (Body Control Module) is behind the glove box.Dome Supervision brown - BCM, pin 63, black 15 pin plugNotes: The BCM (Body Control Module) is behind the glove box.

Also found lt. green (-) in the passenger side A pillar.Trunk/Hatch Pin pink to red - pa kick or BCM, pin 43, wht 15P plugNotes: The BCM (Body Control Module) is behind the glove box.Hood Pin N/A Trunk/Hatch Release blue to purple - pa kick or BCM, pin 30, wht 40P plugNotes: Meter this wire while opening the hatch from the handle on the rear hatch.

The BCM (Body Control Module) is behind the glove box.

On vehicles with the Intelligent Key, instead of the BCM, this wire goes to the Intelligent Key Unit behind the glove box, white 40 pin plug, pin 24.

The hatch release motor wire is orange to red (+) in the passenger kick or BCM, pin 53, white 15 pin plug.Power Sliding Door N/A Factory Alarm Arm green to yellow - dr kick or BCM, pin 8, wht 40P plugNotes: Meter this wire while turning the key in the driver door key cylinder. This will also lock the doors.

The BCM (Body Control Module) is behind the glove box.Factory Alarm Disarm brown - dr kick or BCM, pin 7, wht 40P plugNotes: Meter this wire while turning the key in the driver door key cylinder. This will also unlock the doors with a double pulse.

The BCM (Body Control Module) is behind the glove box.Disarm No Unlock see factory alarm disarm Tachometer blue ac ECM, gray 32 pin plug, pin 13Notes: The ECM (Engine Control Module) is on the driver side strut tower.

Can also go to any fuel injector and use the wire that is NOT lt. blue.Wait to start N/A Brake Wire red + brake pedal switch or either kickParking Brake lt. blue - parking brake sw or cluster, pin 10Horn Trigger pink to red - horn switchMemory Seat 1 N/A Memory Seat 2 N/A Memory Seat 3 N/A Interface Module: Category:Immobilizer Bypass Required:Yes Type:TransponderPart #: 556UWAlternate Part1 #: DesignTech 20402Alternate Part2 #: DesignTech 29402Notes: Standard on all models.

[reyes1212]

Oh wow you get all that, Chrispd?

[Chrispd100]

Yep.... i got it... installing it tomorrow

[BenzTech Gone Versa]

If anything I would get it installed by a nissan tech because they know what everything is, iyt wont be cheep but it will be worth it.

I got mine done from the dealer. the guy took 30 mins to do it and it was in the deal we made....free.

[faction]

No fair! I asked my nissan guys if they could do it and they said no.I'm bummed out now.

Maybe I need to call another Nissan dealer?

[Chrispd100]

ook... im stuck on the lock and unlock part... the codes given are not the right wires... and i can;t figure this out for the life of me... any body want to help?

[Clipsed]

take it to a shop

[reyes1212]

he got it

[Chrispd100]

Ok update..... everything has been put together and is ready, however the remote start part is the only part im stuck on... i can hear it click and do something but have to look into it a little bit more.... but the alarm it self is great.. Thanks for the wire codes..

[Kolk1]

On the remote start, when you hear it click, does all your dash lights, and acc come on, then it does not crank, then everything shuts off?

If so, then you either A) have the wrong Acc or ign wire, Or B) dont have the system programmed properly. Are you trying to do Tach, or Voltage? I always programmed my installs for voltage.

If its cranking and not starting, Either A) Crank time too short, Or B) Bypass module not programmed properly.

Beyond that, I suck at troubleshooting, without seeing the vehicle in front of me to test everything.

[Ever Victorious]

Did you get an immobilizer bypass? If not, what you're hearing is the car not reading the chip that's embedded in the key, and preventing the car from starting.

[Kolk1]

It would still crank, or start than immediately die, if it was the bypass module.

If its just a click sound, then not doing anything, im leaning towards not programmed for the correct tach or voltage.

Or by some odd chance, he has the brake wire hooked up to a constant 12v source.

[Chrispd100]

Ok update..... everything works perfectly, THANKS FOR ALL THE HELP. I needed to go buy a immobolizer and put my spare key in it for the car to start.. and as soon as i put that in the car, it starts right up.... I LOVE IT... i have a good alarm for my V so i don't have to worry as much anymore and just for fun I can start my car with a bunch of people standing around it and impress them.....

[reyes1212]

Show off

[Chrispd100]

I try, what can i say.

[reyes1212]

That you sir, are a show off. lololol but yeah if and when I get the auto start you better give me some 2 cents on how to do it, Chris.