wiring an underbody kit

[thechronic]

i bought an LED underglow kit, and it has a dash controller which i am mounting right under the glovebox so as to have it near to the battery, but i cant find a way to get the wires through the wall between the interior and the battery. whats the best way to do that?

[joe603]

Actually, you should use the drivers side to get to the engine bay. I have a 4ga wire for my amp, so you shouldn't have any problems with smaller wires. Just look for a rubber grommet by the master cylinder area.

[thechronic]

so should there be a place where i could obviously see to get through there?

[infinititech1]

yup...its a big rubber grommet

[lucky70400]

On my old cars, I used to just drill a hole right through the firewall. Not sure how safe that is, but eh.