Post by
ddwebb »
https://forums.nicoclub.com/ddwebb-u257864.html
Fri Sep 09, 2016 5:54 pm
well semi-good news.
I unhooked all wires from the pigtail to the climate control. Started fresh.
the block M102, i could see very very tiny numbers on top and it was labeled in single digits, one side said 1 - 8 the other side said 9-16, had nothing close to what the actual number pins on the wiring document where they should be 21-28, 29-36. So working with that lousy notion, i found the black wire on pin 32 and counted them around.
I had similar issues with with M103, and the modules in the car, M105 and M104, all screwed up.
So i really tried to make shift the pin numbers and color of wires and match.
I had had 4 wires left from my auto a/c: pin 10 (green, yellow stripe), pin 5 (light green with silver around it), and the 2 pink wires.
So i turned the car on and i got power to the auto a/c, i can move from speed of blower, modes seems to work, econo seems to work, But.. i have nothing but HEAT. I didnt drive around but ran the engine and had temp set to 65 and had nothing cool coming out.
I labeled all the wires based on the document and what i could see on the wiring modules but that seemed to make things worse, then SRoberts suggested that the wires could be backwards. So started out fresh and got better results.
thxs
So not sure where to check for that problem????
Plus during all this messing around, my interior lights stopped, the turn signal stopped and my lock doors will not work if the key is not in and turned.
I have one turn signal light bulb out, tried to figure out how to get to the bulb but have not found it yet.
i looked at the fuse for turn signal and interior lights and they seem to be good.
So, any suggestions for the above issues left?
Tomorrow morning i have a auto handy man coming to help out with the a/c issues and install my Nav/radio that i have not even started on.
thanks for all everybodies help .