SRoberts:
what did you add when you installed the Joying 7" Nav to fill in the open space instead of leaving dead space?
I am thoroughly befuddled.
I am so close but still far behind as well. I so wanted this to work first time.
My wire adapters i have like this:
wires located a pins:
M102: 21, 22, 23, 24, 27, 28, 29, 30, 31, 32
M103: 5, 8, 9, 10, 12, 13, 15, 18. 19. 20
M104: 1, 2, 3, 6, 7, 8, 9, 10, 11, 12, 15, 18, 19, 20
M105: 21, 22, 23, 25, 26, 27. 28, 29, 30, 31
when i mesh the Non-Nav diagram and the Nav diagram together, i have left over wires.
When i look over the one page that shows them side by side, there is a 4 wire section for Navi that says to use 37, 40, 38 on Navi. what block is that from?
there are 2 block of wires that came from the Navi, i have no idea as to what block number they are. have not found them in any document so far.
Then at the bottom is the Illumination and ground and rear defogger, do they come out of M104/M105? If not, where?
Now i take these wires from these pins and a lot of them do not match up. some wires are missing in places where to connect.
From those of you that was successful in getting the automatic climate control inserted into your bezel where a NAV/Climate Control was, do these wires and pin location look right?
I have gone over and over and at one time i had power to the CC and blower on high and the digital temp i could move up and down but the temp into the car did not do anything except heat and middle of summer we dont want heat and nothing else.
I have broken down with my wife's push to seek someone to help me finish this what i had hoped was an easy job.
If any of you have suggestions to help me out before Saturday where i can try again before my hired help arrives, i would so greatly appreciate it.
I am trying everything i can to get this piece working.
So if you all can provide guidance, pictures, actual items to help, everything will be most appreciated.
thx for everything.
ddwebb