Redoing all bushings - Question about parts needed - '94 D21 2WD

Forum for Nissan wheel fitment, tire selection, suspension setup and brake discussions.
LazerD21
Posts: 10
Joined: Sat Feb 19, 2022 1:51 pm
Car: 1994 Nissan D21 XE

Post

Just replaced some very old balljoints and am going to go back and do all bushings... should have been patient but needed the truck for a few days.

Currently getting parts ready and found some bushings I never used on my previous truck. Below are the parts I found with links to Rock Auto listings.

Bushings I currently have sitting in the garage:
  1. Energy Suspension Complete Shackle Set: 72103R (2x box sets)
  2. Control Arm Bushing: MOOG K9546 (2x)
  3. Upper Control Arm Bushing: MOOG K9209 (1x, comes with two. Front and rear?)
I'd like to put in Polyurethane Sway Bar bushings and am looking at the Energy Suspension 75108R set, don't really care about the red.

What other bushings and rubber/boots should I take care of when doing all this rubber? What parts am I missing?
Truck is a 2wd, '94 D21. Lifted enough to fit 15" rims.


Return to “Nissan Tires, Wheels, Brakes and Suspension”