CAS Install (Searched)

[S^13]

If someone could let me know page # in the fsm for CAS install or link a thread to how to do it it would be much apreciated! I searched for a long time and cant seem to find it Thanks in advance.

[dattodude]

CAS? Cam Angle Sensor?

1. align "half moon" drive into cam end. Push in2. Finger tighten 10mm bolts.3. Set timing with a timing light.4. tighten bolts up properly.

Do you want pinouts for an aftermarket ECU install?

What's hard about this? I must be misreading your question.

Cheers,Chris

[S^13]

well its in but when I go to do the timing I cant read it at all I thought if you remove the cas (crank angle sensor) then you had to re-install it a certain way.

[NeedCAforS13]

nope, see this for setting timing though:

zerothread?id=89419

3/4 of the way down...

Sean

[float_6969]

nope, see this for setting timing though:

zerothread?id=89419

3/4 of the way down...

Sean

Sean, I love the FAQ! They're so...comprehensive!

[S^13]

nope, see this for setting timing though:

zerothread?id=89419

3/4 of the way down...

Sean

thats the instructions i used

[NeedCAforS13]

then whats the problem? the cas only goes in one way. if its not reading on the timing light, try a different one. Make sure you put pickup signal loop from the timing light on the correct way. This is really not a hard thing to do! It would take me all of 5 minutes to go check timing on my car! I don't understand what you're stuck on...