car still wont drive right :/

ONLY for ADVANCED technical discussion about the 240sx!
silent_elite
Posts: 34
Joined: Sun Feb 20, 2011 12:32 pm
Car: 1990 s13 with ka24de swap

Post

hello again nico ppl, thankyou for all of you who have got me this far lol

so car still aint right. starts up and idles at 900rpm bouncing jus a lil bit every few seconds. iv put in a new tps and adjusted it to .47, leave it disconnected for a bit and adjust iacv. go for a spin hoping iv fixed the jerking, drive for 30sec and the jerking starts again. it only happens every now and then it will start giving you wiplash and rpms rev to 2700 real quick then down to like 2500 but if i floor it a bit while its doing this it drives out of it. i park and check my tps and im gettin .52, did i not tighten it enough? and if im parked somewhere after driving for a few mins and im in neutral car idles at like 1400 and when i give it gas the temp needle moves up and down real quick but when i go into 1st it idels bac at 900 and needle stays level. also feels like im not getting that much power, ill be in 1st and have the gas to the ground and it jus gradually accelerates but sometimes i get a lil bit of pep from it. i just replaced the fuel filter and it didnt jerk NEARLY as much and im bout to order my 255fp. so what do youll think nico?

thanks guys and sorry for the long sentence lol


User avatar
NicUzumaki
Posts: 36
Joined: Tue Oct 13, 2009 1:14 pm
Car: 240sx-dohc swap
82dodge Rampage[RIP]

Post

ur tps might just have crapped out on you, as for the quick rpm pick up im not sure but check to make sure ur throttle cable is secured and not getting tangled or interference

when my tps went i felt a substantial power loss along with erratic rpms

silent_elite
Posts: 34
Joined: Sun Feb 20, 2011 12:32 pm
Car: 1990 s13 with ka24de swap

Post

its a brand new tps

User avatar
moso
Posts: 801
Joined: Sat Jul 04, 2009 5:14 pm
Car: 89 240sx ka24de 5spd
90 240sx ka24de RIP

Post

check the ecu for codes, report back.


Return to “240SX Technical Forum”