Cam Bolt

[1sikS13]

what size is the bolt on the cam....before i go out buying a whole ****in set of sockets i aint ever gonna use...Anyone wanna gimmie a clue please

[scole]

27mm I believe? Someone else can verify.

[H8tred]

24mm or 15/16 on the bolt, and a 1 inch or large adjustable on the cam...

http://jimwolftechnology.com/w...E.PDF

[offroadbob]

Times like these is when Harbor freight tool company is bomb. You can buy a set of sockets you are only going to use a few times for the price of a single socket!

[H8tred]

MIT is pretty good too. I'll tell you this, I have Snap on, Matco, and cheap Prosource tools, and I use my Prosource ratchets more than the Snap ons. They're very loose 64 tooth ratchets, so I get about 5 degrees of swing, and I can still turn a fairly loose nut or bolt with them.

My Snap ons are tight, and 32 tooth. They did just come out with some 80 tooth ratchets though. At 80 bucks, I might have to pic one up.

[1sikS13]

thanks fellas. Harbor freight here i come

[S13xCrazy]

the bolts that hold on the cams to the head are 10mm.

The large bolt in front to hold the cam sprockets on are 24mm.

and then you need a 1inch wrench for one came, and then a 1 1/16 or whatever the next size up is for the other.

[1sikS13]

not 1 1/16 i have that had to use that for the crank bolt

[murda-c]

the cams seem to have an uneven shape on the hexagonal part where you put the wrench. one side is 1" and the other is like 1-1/16". so every time you turn it you have to change wrenches.

[1sikS13]

can anyone find the right up that positronone did on the exhaust cam swap?

[H8tred]

zerothread?id=294891

Is this what you're talking aboot?

[1sikS13]

zerothread?id=294891

Is this what you're talking aboot?

that is the one i must have been confused as to who created that thread obviously. My bad but thanx h8tred

[H8tred]

Not a problem, let us know how it goes.