1991 Motor Pull please help

[THEdonSIMMER]

I am almost ready to pull the motor out but I can not for the life of me find out where to hook up the hoist.. I have been looking the whole time I have been taking the motor apart but can not find it. any pictures would be nice. Please and thank you.

[NolimitZ32]

There are a few ways this can be done, the engine itself doesn't have actual lift points. Best and easiest way is to buy one of these: http://www.z1motorsports.com/product_in ... ts_id=2940 other than that I've seen people use tow rope under all 6 intake runners and I used to personally use a spreader bar/bracket assembly that my dad and I fabbed years ago mounted to the 4 bolts (2 either side) of the intake manifold.

[THEdonSIMMER]

ok thanks

[NolimitZ32]

No worries, and honestly for the price the Ramey slinger can't be beat. Its not the greatest workmanship, its just some stock square tube and flatplate and a couple of bolts but it does the job very well. Hell if you have a welder at your disposal you could make one.