Post by
mppp78 »
https://forums.nicoclub.com/mppp78-u308428.html
Sun Feb 05, 2023 9:13 am
As far as the IACV relearn goes I've read in the following if not replacing the throttle body, but just disconnected the harness connector (steps 1-3) below, but in my Chilton a whole lot of more steps involving turning on/off, accelerator depressed etc. Which is correct? Steps 1-3 Below from Nissan manual or Chilton with about 10 steps but I will say Chilton states when a new one is installed so I suppose that's the reason for extra steps? Thanks for input all!
1) Make sure accelerator is fully released
2) Turn ignition switch on (btw I assume they mean turn engine on right because chilton says turn on engine?)
3) Turn ignition switch OFF and wait at least 10 seconds