treadstone manifold

[1993ka24det]

i got the manifold and found out that it is going to run in to the master cylinder and brake lines but just touching is there a master cylinder that is smaller like off of a 300zx

[eazye2000]

The manifold you speak of, is something along the RevHard manifold, correct? I've only seen it on a very few websites...But I'm sure it can be made to work... Here's a tip that I've 'heard' and not tried..You can put a washer, or two behind one side of the brake master. You put them behind the bolt that is closest to the inside of the car. Towards the passenger side of the master. This will 'point' the master a bit away from the manifold.Again, I've only heard that people do it. I've not personally done it...

[WDRacing]

Wouldn't do that, but you can tilt the motor by adding a hockey puck or two under that side. There are a few threads on this, search for hockey puck. You can also use an on-center turbo, which is what it's actually designed for.

This is On-Center



This is tangential

[krazydriver]

The treadstones can be used either as top or bottom mount manifolds.

If you have the ability to run it bottom mount, i think the only issue is that if you have a t04 compressor housing you might have to grind a little material off the engine mount bracket, i'm pretty sure the straight t3 would fit fine bottom mount.

idk, i just got one for a good price the other day. Now i gotta wait till i get the rest of my turbo stuff to put it in.

[s13_maniacs]

i got the manifold and found out that it is going to run in to the master cylinder and brake lines but just touching is there a master cylinder that is smaller like off of a 300zx

get another mani...cheap parts only cause trouble and money

[Florida240sx]

Any pics? Keeping ac?

[2FourTee]

get another mani...cheap parts only cause trouble and money

This isn't some ebay chinese manifold. This is a sturdy, cast iron manifold. While the design may limit the type of turbo you can use, I don't see anything "cheap" about it.

[480sx]

Treadstones a solid manifold for sure, it wont ever give you any problems except the ones your having now. Also its not a cheap one either..