SR Wiring question - left over wires???

[turblu]

Ok guys - I'm using the heavy throttle wiring diagram for the two plugs which go up and behind the battery. Once I cut the Ka plugs off I will have a total of 8 unused wires according to there wiring chart.

Here is a link of the diagram -

http://srownersclub.com/faq/index.asp

Pictured here I have the wires on the Ka harness needed according to the diagram seperated from the unused ones via a vice grip.

And here, the ones to the left are listed on the diagram the ones to the right are extra(15 left over). On this piece I have 3 brown wires. It states to use the brown wire for the O2 sensor power... But which of the three do I use? I also have 2 wires which are *Blue w/ Red Stripe*, which of those two? The thicker one or the thinner one?

What do I do with the extra wires? Do I continue to match colors with the rest of the plugs or do I simply snip them and move onto to putting the engine in?

[boost_creep]

whatever is not mentioned in the write-up,dont worry about.just tape them up.

[Henry G]

There are quite a few wires that are not used. Just tape them up and make sure you have all the needed wires hooked up. It would suck to go back later.