Skinny O2 sensor remover?

[Miss 180]

So i finally figured out what the deal was with my sr running like crap. It was a combo of the knock sensor and o2 sensor....just replaced the knock sensor today (which truely is a pita to do!), runs soooo much better but still some hesitation and still throwing o2 code. So long story short, anyone know where i can get a skinny o2 remover or anyone have one that they would like to part with? I would greatly appreciate your in put.
Modified by Miss 180 at 6:29 PM 2/7/2010

[DuckyD]

Your local autoparts store should have something (to either buy or rent). Or get this badboy-> http://www.harborfreight.com/c...99850 and return it after using it.

[Seishuku]

Just do what I do, cut the end off a junk wrench the size you need, and weld a junk socket on the end.BAM! Instant crow-foot. Perfect for putting in and removing O2 sensors.

[MES14AN]

BURN.

Your local autoparts store should have something (to either buy or rent). Or get this badboy-> http://www.harborfreight.com/c...99850 and return it after using it.

[Miss 180]

sorry it took so long to reply. i got it off the hard way. crescent wrench and a hammer. soooooo. im still stumped. Its not throwing any codes now, but im still eating gas like crazy, fowling plugs, and hesitation. My next (uneducated) guess would be check out my fuel pressure regulator. any other suggestions?

keep in mind im completely bone stock motor wise. ive already replaced the temp sensor, knock sensor and o2 in my quest of getting her running right.
Modified by Miss 180 at 9:04 PM 2/20/2010