It should be here monday, and be dropped in the Z32 then. Figure it is easy, but looking for info, searched to no eval. Thanx craig

The body of the Walbro is a lot smaller than the standard one, a bit of plastic tube stuff goes around the walbro along with the rubber off the standard pump.

I took some photos when I did it, I'll dig them up.

Mine is a universal i think, made by walbro, sold as trickflow. 125$ us. not bad i think.

Old pump all together

The old pump rubber that you have to remove to put on the walbro so the clamp works well

The Walbro, the rubber that the walbro came with (red arrow), and the rubber off the old pump (green arrow)

The whole lot reasembled. Had to solder a couple of wires in up the top

The new filter didn't fit, so I reused the old filter with a new expansion washer

Thanx a lot for the pics. Hope it helps others later too,

Did it a week ago or so, It is alot skinnier and shorter in length then the stock unit. I used an radiator hose, sliced up a bit to help fill the space in rubber boot, reused stock mounting, piece of cake, all in all, 20 -30 minute job. Part was 124 from Summit, made by Walbro, sold as a Trickflow piece, I think it was for a Stang, but filter, and all fit great, just had to mount it low in the boot, to keep filter low in tank. Running out of gas with 1/4 tank would suck.