hey guys just looking to see if anyone is intrested in an old 1980 rx-7.
the car has a mariah wide body kit that needs some light body work(from a body mans view nothing serious
has a whale fin/wangan wing(starting to crack where it was molded just sand and glass it and you'll be fine its riveted to the body so it won't come off.)
hre 504 meshes(super rare since not alot came in the 4x11.4 pattern)
a 4 point racing harness
after market rear and front sway bar
tokico illumina shocks not sure with springs but i'll check
racing header
front strut tower bar
aluminum racing flywheel
came with a 12a but a 13b was swapped in i believe a 6 port
engine has been bridge ported allready
engine does not run due to a rotor bearing blowing so you need a new one
has more extras, this car is built for pure racing, the other turn offs are it has no emissions hooked up and is under a race title for along time so you'll need to start from scratch to get the car registered. Its not hard just fill out the paper work, maybe an inspection but i doubt it since its old, pay the fee(idk how much it is) and get a smog hook up for like 150 and your good to go! The engine is out and so is the tranny i was planning on using rx-8 guts and building the engine myself but can't now due to being in school again. I'll send pics to ppl interested.
looking around 2.5 with out the hre's these baby's are awesome and 3.4 with the hres meshies. With 1k or 1.4k you can rebuild the engine and beat this thing hard. I was planning on taking this to thunderhill this summer but not anymore.
Modified by silpena at 11:41 AM 3/12/2008
Modified by silpena at 1:26 PM 3/14/2008
Modified by silpena at 10:24 PM 4/4/2008
