s14 vq wiring guide wanted

[kyskater]

so i have been looking for a wiring diagram for the vq35 into the s14. i am looking at people using the whole body harness from the 350z but this is my dd so i really dont have time to take the whole interior and fenders off to do this. i will pay to have the ecu reflashed if i can do the harness myself. also any additional swap info would be greatly appreciated thanks

[kyskater]

bump

[Andy4106]

you have a long way to go. unless you plan on using the 350z bcm you will have to go stand alone. get on ebay and order a 350z service manual. it will be one of the better investments you make.

[Andy4106]

and there is no way you can do this swap to a dd car. your high if you think that will happen. well you can dd it after your done. but unless you have no job or life to where you dont drive anywhere you might as well forget the swap.

[kyskater]

i have no job and college isnt far from being done for the year..

[Andy4106]

its going to take you a lot longer than you think. but ok.

[irax]

send me an email

ibsemailis@gmail.com

i can just sell you my harness, uses maxima ecu and bcm and nats all ready and wired up just need ecu and bcm

[irax]

in case anyone still needs a write up on the swap it can be found here
http://zilvia.net/f/engine-tech/389016-how-wire-vq35-into-your-95-s14.html#post4083416

[dudewutup]

irax beat me to it,glad to see my info getting around. im just poking around getting ideas and saw this thread.

[Taylor_Durdan]

i've actually done this swap successfully a few times now without using the BCM. but it does require the ECU to get reflashed using the osiris tune.