Fog lights from a Nissan Tiida to a Nissan Versa! How to......

[Scuba Steve]

Here are the steps to install fog lights

Now the electrical



Run the wire through the grommet, tape the wire to a cut coat hanger and poke it through.I made a rubber seel out of screen door spline, I put a 18 gauge wire 1 inch long in the center and crazy glued the ends together.I drilled out the blank plate for these switches one for fog, one for inside LEDS, and the other for outside LED'sFactory look................................





Modified by Scuba Steve at 7:32 AM 8/30/2008

Modified by Scuba Steve at 7:34 AM 8/30/2008
Modified by Scuba Steve at 1:35 AM 8/31/2008

[pfc369]

i did not see any relay in your photo at all.

[Scuba Steve]

i did not see any relay in your photo at all.

I do have a relay installed plus running the wire through the firewall, I have to post those pictures up later, I ran out of time.......

[superskunk]

those fog lights dont fit into the versa fog light finishers? you know the pre-cut ones

[2dr_sentra]

why not just buy oem fog lights

[Scuba Steve]

why not just buy oem fog lights

Well if you want to dish out $325.00 go ahead, I paid $25.00 for my parts, and the fog lens are made of glass not plastic.

http://www.courtesyparts.com/b..._7637&


Modified by Scuba Steve at 1:19 AM 8/31/2008

[Versa Madness]

I paid $25.00 for my parts, and the fog lens are made of glass not plastic.

Where???

[Scuba Steve]

On Ebay, it's no longer listed

[Shad0wXCalibur]

why not just buy oem fog lights

Because $300 is not at all worth it for factory lights that make no real difference on the road.

[Visaversa]

Nice install but why not use the pre-existing factory wiring already hanging behind the fog light blanks. I was lucky enough to get the Tiida kit off of Ebay for $125.00. Had to buy the OEM turn-signal stalk to achieve the stock switch location but that wasn't necessary.

[Scuba Steve]

My SL technology did not have pre wiring for fogs. This is Canada, eh? lol