ca18det fuel rails

[Chinamandrift]

just some extra info i just found out.....

the 4 port fuel rail and the 8 port fuel rail are different......

i ordered a sexy fuel rail because it was available

then when i tried to match everything up to make sure it works .......

i noticed the holes are in different locations hahaha

so in conclusion my bran new 8port sexyness fuel rail dont fit my 4 port setup

i dont want anyone else to make the same mistake i did.....

maybe i should stuck with the stupid 4AGE haha not CA18det FTW!!!!

[float_6969]

Not be be a jerk, but if you had asked, I could have told you that it wasn't going to work.

Sorry man!

[ch187]

post some pics and sell the rail. im interested. ****.

[Chinamandrift]

haha its no big deal haha......the thought never came to my mind .....or else i would have asked .......i didnt think about the fitment until the rail arrive on my door step........haha i know if i had a question....u and many others would have the answer to it.........so i just wanted to let everyone know about my stupidity.......and prevent the same mistake

anywayzi dont know if im going to sell it yet ..but when i do i will post it on here ......just woundering ........whos interested? anyone interested in a 4 port version?

[themadscientist]

Just make one. Ross machine hooked me up with rail stock for chump change. The tool to drill the holes is no joke but it's a one shot job with the special bit..http://www.rossmachineracing.com/

[ch187]

+1 for tms. ross has some baller stuff. my buddy still has like a 5 foot section of that rail sitting around.

[themadscientist]

Here is what I just got in from them.2 feet of dash 8 rail stock

The special bit to drill for 11mm injectors

new rail next to a stock CA18 rail

awesome service and great prices.

[Chinamandrift]

nice ...maybe i shoulda went that route ......dont u need a special drill press to drill the holes ?

[themadscientist]

no. I would recommend you clamp the rail in a fixture to keep it from shifting and use a drill press to drive the holes. The drill press will ensure that all the holes go in straight and you can set the stop so they all terminate at the same height. The special tool is nothing more than a standard drill bit that has been turned down.I'm getting the -10 rail for the CA project.