Blitz SSBC Install Help

[hnugen]

I need to verify where these vacum lines on the solenoid go. There are no English instructions, as a lot of people on toher boards cant find an English manual. Any help is greatly appreciate.

[S14tat]

#1 is the input from a boost signal, the #2 is the port that goes into the wastegate on the top of the diagphram. #3 you leave open, that is the breather port.

[hnugen]

Thanks man. I couldnt find any solid info by googling.

[S14tat]

i was actually surprised that no one else answered this thread in such a long time. i guess no one else but us uses the blitz EBC.

[Darius2250]

I had a question about this, I am not running an external wastgate, so would #2 go to my actuator? and I thave a T25 that is on a CA18DET, there is a line that comes from the turbo housing, would this be considered the #1 input from the boost signal? I do have it T'd off this line and the controller is seeing the boost, well the numbers go up and such,

Thanks.

[S14tat]

you just put the boost signal into #1, and have the #4 go into wastegate. don't forget the flip the mini selector switch in the back of the boost controller to AC ( actuator ) not WG ( wastegate )

[Darius2250]

#4?

[S14tat]

#4 would be the port between #1 ands #3, it looks like a #4 on my comp, if it looks like any other number on your comp, then its the one between 1 and 3 lol

[Darius2250]

ok whew! I was like oh no I don't have 4 ports only 3 , thanks for all the help I have it all set up right, (except the silinoid isn't attached to the body) but all I can boost to to is 9psi(stock) so I am going to have to look into this.

Thanks again.